Analogue Connections - Kenwood CR-ST100S Mode D'emploi

on the remote control.
Note: Some terminal devices require a PIN code when connecting, then enter "0000".
11.2 Automatic connection after pairing has already taken place
If the source is switched from "Bluetooth Audio" or the radio is switched off, the Bluetooth connec-
tion is disconnected. If the radio is switched on again or switched back to the "Bluetooth Audio"
source, an automatic connection is established.
Note: If an automatic connection is not possible, please proceed as follows:
Press the <MENU> button and select "View details". Then open the "Paired Device List", to
select and connect the desired device. Press the <OK> button to establish the connection and
"Connected" appears briefly on the display.
11.3 Pairing another device
To connect another device to the radio, please press the <MENU> button and select"Setup Blue-
tooth". This will disconnect the current connection.
Now proceed as when you first pair a device. Afterwards, this device is also saved in the list of paired
devices and can be selected via the corresponding menu (see above). A maximum of 8 devices can be
saved.
11.4 Interrupting the Bluetooth connection
If you want to interrupt the connection to a paired device, please press the <BT PAIR> button on the
remote control for 2 seconds.. The radio then switches back to pairing mode.

12. Analogue connections

12.1 Aux-In
To play music, external devices such as e.g. MP3 players, DVD players or game consoles can be con-
nected. To do this, please select the source "Aux-In" in the main menu.
12.2 Line out
You can use this analogue audio output to connect the radio to an external amplifier, for example.
The volume of the radio can be turned down completely, this has no influence on the playback volu-
me of the external amplifier. The corresponding connection cable is included in the scope of delivery.
Note: Switch off the radio before connecting an external device to it.
19