Symbols Used In This Manual - KBSOUND eisSOUND PLUS 42695 Mode D'emploi

4
2. General Operating Notes
1.- None of the functions (except ON/OFF) work unless the remote
control is in "on" mode.
2.- Functions pertaining to operating the audio signal only work
when "mute" is cancelled.
3.- The LED on the data receiver can change color depending on the
control unit's mode:
OFF the control unit is off
£
£ GREEN the unit is on
RED the unit is receiving data from the remote control
£
4.- When activating or canceling a function (loudness, stereo/mono
or mute):
1 RED flashing: function is activated
4 RED flashes: function is cancelled
1
5.- The mains plug is used as the disconnect device so, once the
KBSOUND®PLUS is connected to the mains, it will remain powered
even if it is in the OFF state. That means that the OFF state (as
indicated in this manual) really means a "standby" state

Symbols Used in this Manual

The control unit generates sound signals to communicate the
status of operations carried out. These signals are reflected in
this manual as follows:
BEEP A short BEEP sound signal indicates that the data
was received.
A long BEEP sound signal indicates that an
BEEP
operation was correctly completed.
BEEP BEEP BEEP
A series of BEEP sound signals indicates that a
clearing operation was executed or that there is an
error.
BO BEEP
A BO BEEP sound signal indicates that the memory
pre-set station tuned at the moment is station
number one, or that the tuner's frequency is set at
87.5 MHz (the lowest on the dial).
Certain operations require a remote control key to be held down
for a certain amount of time. This is indicated in the manual by
a hand symbol next to the key.
CC-1088-05.1