Connecting The Charging Cradle; Inserting The Battery And Closin9G The Battery Compartment Cover - Auerswald COMfortel M-720 Notice D'utilisation

Connecting the charging cradle

1. Connect the flat connector (A) on the end
of the wall-mounted power supply cable
(B) to the charging cradle (C).
2. Plug the wall-mounted power supply (B)
into the mains socket.
Disconnect the flat connector from the
charging cradle (C) again:
1. Disconnect the wall-mounted power
supply (B) from the mains.
2. Press the unlocking key (D).
3. Disconnect the flat connector (A).

Inserting the battery and closin9g the battery compartment cover

Warning: Using unapproved rechargeable batteries can cause serious
harm to health or damage to equipment, and also functional faults or
damage to the device. The casing of rechargeable batteries can be
destroyed, or rechargeable batteries can explode.
• Only use original replacement parts supplied by the manufacturer.
E
1. Insert the rechargeable battery with the contact side down (Figure E).
2. Press the rechargeable battery down until it clicks in place.
3. Align the rechargeable battery cover so that the tabs on its side fit into the
recesses on the inside of the case (Figure F).
4. Press the cover to close it until it clicks in place.
If you need to open the rechargeable battery cover again, to replace the
rechargeable batteries:
1. Remove the belt clip (if present).
COMfortel M-720 - Instructions V01 06/2021
Initial Commissioning
A
B
C
D
F
29