Starting The Device; Connecting The Camera - NUK Eco Smart Control 300 Mode D'emploi

network. Please make sure that both plug
sockets (camera and Powerline adapter) are
connected to related phases, which is
generally the case anyway when plug
sockets are connected
electricity meter.
Up to four cameras can be operated using
the same Powerline adapter.
The signals are transmitted using the
Powerline adapter, which is connected to

5.1 Connecting the camera

Please note
• Do not install the camera during a storm.
1. Connect the network cable provided to
the power supply 15.
2. Insert the plug into a power socket that
conforms to the technical data (see
"12. Technical data" on page 35).
3. Position the camera 11 somewhere in the
nursery where your baby will not be able
to reach it.
Radio waves:
– The camera works without wireless
transmission. Your child is thus not
exposed to any wireless radiation.
to the same

5. Starting the device

25
the router or modem using the network
cable supplied.
Your WiFi (WLAN) router transmits the
signals directly to your smartphone (tablet)
once you are located within the transmission
range.
If you are located outside the transmission
range of your local WiFi router, the signals
can also be transmitted via mobile radio
(G3/UMTS) or an external WiFi access point
on your smartphone.
Infrared operation
If the room to be monitored is too dark, the
camera will automatically switch to infrared
operation. Here, the infrared LEDs (IR-LEDs)
6 switch on automatically to illuminate the
room with infrared
transmitted is then black and white.
Note: The range of the infrared light is
approx. 3- 4 m.
5.2 Connecting the WLAN
router
PWR
PL
ETH
1. Insert the network cable provided into a
suitable connection
(modem).
2. Insert the other end of the network cable
into the Powerline adapter 17.
3. Insert the Powerline adapter 17 into a
power supply socket.
light. The image
on your router