Making An Espresso - Krups XP3200 Mode D'emploi

IFU_KR_COFFEE_MAKER_XP3200_ 8000828507-01_Mise en page 1 13/09/10 16:38 Page1
n Without waiting, turn the Coffee function selector (h) to the
position (h2) and let all the water in the tank drain out (Fig. 5). During
this first use, the system must fill up and the water does not flow
immediately.
n If necessary, to empty the water from the container, you can interrupt
the flow by turning the coffee function selector switch (h) to the
position

5. MAKING AN ESPRESSO

W I T H E S P R E S S O G R O U N D C O F F E E :
n Fill the tank with cold water and place it firmly on the machine,
making sure it is firmly in place, (fig. 1, 2 and 3).
n Place the filter (c.1) for 1 cup or the filter (c.2) for 2 cups in the filter
holder (j) (fig. 6).
n using the measuring spoon (d), fill the filter with ground coffee.
(1 dose = 1 cup, 2 doses = 2 cups) in the filter. (fig 8, 9)
n Remove the coffee which remains around the filter.
n Insert and turn the filter holder to the right
n Place one or two espresso cups under the filter holder.
As soon as the device reaches the required temperature, the coffee
light (h3) stops flashing.
n Turn the coffee function selector switch (h) to the
n When the cups are filled to your liking, turn the switch to the
position (h1).
n Remove the filter holder by turning it to the left
n To eject the spent coffee, turn the filter holder over, holding the filter
by the tab so that the spent coffee falls out (fig 11).
For the best results, we recommend that you preheat the accessories
(filter holder, filter and cups) following the steps above without using
ground coffee.
Warning! Do not remove the Filter holder when the Cof-
fee function selector switch (h) is in the
and the coffee is flowing.
(h1).
English
(fig 7).
position (h2).
.
position (h2),
11