Cleaning And Care - DS Produkte FY-988C Mode D'emploi

EN
1. Wind up or unwind the mains connecting cable on the bottom of the base station (5)
to the length you want and then place it in the slot which is provided for it on the edge
of the base station.
2. Insert the mains plug into a easily accessible socket.
3. Place the base station on a dry, even, fi rm, water and heat-resistant surface. Do not
place the device below kitchen wall units or similar cupboards. The rising steam could
cause damage to them!
9. The device automatically deactivates once the water has boiled. The On / Off switch
sets automatically to Off position and the LED lighting switches off.
10. Take the kettle off the base station and carefully pour the water into a vessel. Keep
the lid closed when pouring out the water.

Cleaning and Care

PLEASE NOTE!
■ Regularly descale the device.
■ The device is not dishwasher-safe.
■ Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to
clean the device. These can damage the surface.
• If necessary, wipe down the kettle (7) and the base station (5) with a clean, damp
cloth.
• Keep the device ready to operate. Remove limescale deposits with a descaling agent.
Follow the instructions on how to use the descaling agent.
• If the interior of the kettle is dirty, it can be rinsed carefully with detergent and clear
water. Make sure that no water gets into the contacts on the bottom of the ket-
tle! Do not immerse the kettle in water! This could cause a short circuit.
• The kettle can be stored on the base station when it is not being used.
16
4. Open lid (9) by pressing button for opening the lid (1).
5. Fill the kettle (7) with at least 0.5 litres and max. 1.7 litres
of water. Insuffi cient water will cause the device to switch
off prematurely. If the top marking is exceeded, water
could splash out during the boiling process.
6. Close the lid. It must engage.
7. Place the kettle on the base station.
8. Push down the On / Off switch (4).The device will turn on
and the LED lighting (6) will illuminate. You can interrupt
the boiling process at any time by pulling the On / Off
switch up.