Initial Use; Unpacking The Air Purifier; Setting Up The Air Purifier; Using The Device - Beurer LR 220 Mode D'emploi

6. Initial use

6.1 Unpacking the air purifier

1. Open the cardboard packaging.
2. Remove the device from the top of the box without opening the film bag.
3. Now remove all plastic films. Remove the combi filter from the device (see "Filter change" section) and
take it out of the plastic film. Then re-insert the combi filter into the device.
4. Check the device, mains plug and cable for damage.

6.2 Setting up the air purifier

1. Place the air purifier on a firm, level surface to prevent vibrations and noise.
IMPORTANT
If you want to reposition the air purifier, always use both hands to support it.
2. Set up the air purifier in such a way that provides 30 cm clearance on all sides.
3. Make sure that the air inlet and air outlet are never blocked.

7. Using the device

7.1 Switching on the air purifier

1. Follow the instructions in the "Initial use" chapter.
2. Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard.
3. Press the ON/OFF button
Note
The air purifier is at setting I at initial start-up.

7.2 Selecting the fan speed

The air purifier has three permanent fan speeds (setting I / setting II / night mode) and a 15-minute turbo mode.
Setting I
XXX.XX_LR220_2020-02-20_01_printing_BEU
The air purifier fan operates at low speed.
Setting II
The air purifier fan operates at high speed.
Turbo mode
In turbo mode, the air purifier fan operates at the highest setting for 15 minutes. I and II start to light up on
the display. After the 15 minutes have elapsed, the air purifier automatically switches to setting I.
Night mode
In night mode, the air purifier fan operates particularly quietly at the lowest setting. The illuminated display
goes out after 5 seconds. To exit night mode, press any button. The fan continues to operate at setting I.
Z
Z
Z
Press the ON/OFF button
Press the fan speed button
Press the fan speed button
Press the fan speed button
Press the fan speed button
XXX.XX_LR220_2020-02-20_01_printing_BEU
Z
2H
Z
Z
ON/OFF FILTER
Z
2H 4H 8H
Z
Z
to switch on the air purifier.
ON/OFF FILTER
XXX.XX_LR220_2020-02-20_01_printing_BEU
Z
Z
Z
ON/OFF FILTER
XXX.XX_LR220_2020-02-20_01_printing_BEU
2H 4H 8H
once
Z
2H 4H 8H
Z
Z
once
ON/OFF FILTER
Z
2H 4H 8H
Z
Z
twice
ON/OFF FILTER
Z
2H 4H 8H
Z
Z
three times = Air purifier switches to night mode
ON/OFF FILTER
Z
2H 4H 8H
Z
Z
four times
ON/OFF FILTER
XXX.XX_LR220_2020-02-20_01_printing_BEU
ON/OFF FILTER
XXX.XX_LR220_2020-02-20_01_printing_BEU
XXX.XX_LR220_2020-02-20_01_printing_BEU
4H 8H
2H 4H 8H
= Air purifier switches on and starts at setting I
= Air purifier switches to setting II
= The air purifier switches to turbo mode
= Air purifier switches back to setting I
20