Candy CDIMN 4D622SB Mode D'emploi page 96

l
Press the button again to increase the
delay in hours (each time the button is
pressed the delay is increased by 1 hour
to a maximum of 23).
l
To start the countdown, press the "START"
button. The display will show the time
remaining to the begin of the programme.
(Only for free-standing models)
The length of the selected cycle will
be shown on the display. At the end of
the countdown, the programme will
automatically start and the length of
the selected cycle will be shown on
the display.
Proceed as follows to cancel a delayed start:
l
Hold the "RESET" button down for at
least 3 seconds. "00" will appear on the
display and some audible signals will
sound.
l
The delayed start and the selected
programme will be cancelled. The display
will show two lines.
l
At this point, to set off the dishwasher, a
new programme and any option buttons
must be selected, as indicated in the
"PROGRAMME SETTINGS" paragraph.
Muted END-OF-PROGRAMME
signal
The audio signal may be muted as follows:
The dishwasher must ALWAYS be off
before start of this procedure.
1. Hold down
SELECTION" button and at the same
time switch on the dishwasher by
pressing the "ON/OFF" button (a short
audible signal will sound).
2. Keep the "PROGRAMME SELECTION"
button pressed for at least 15 seconds
(during this time 2 audible signals will
sound).
the "PROGRAMME
3. Release the button when the second
audible signal sounds ("b1" will appear
on the display to indicate that the alarm
is on).
4. Press the same button again ("b0" will
appear on the display to indicate that
the alarm is off).
5. Turn off the dishwasher by pressing the
"ON/OFF" button to confirm the new
setting.
To turn the alarm on again, follow the same
procedure.
Memorization of the last programme
used
The last programme used can be memorized
by following the below:
The dishwasher must ALWAYS be off
before start of this procedure.
1. Hold down
SELECTION" button and at the same
time switch on the dishwasher by
pressing the "ON/OFF" button (a short
audible signal will sound).
2. Keep the "PROGRAMME SELECTION"
button pressed for at least 30 seconds
(during this time, 3 audible signals will
sound).
3. Release the button when the THIRD
audible signal sounds ("A0 " will appear
on the display to indicate that the
memorization is off).
4. Press the same button again ("A1" will
appear on the display to indicate that
the memorization is on).
5. Switch off the dishwasher by pressing
the "ON/OFF" button to confirm the new
setting.
To disable the memory feature, follow the
same procedure.
96
the "PROGRAMME