Throubleshooting And Warranty - Candy CDIMN 4D622SB Mode D'emploi

19. THROUBLESHOOTING AND WARRANTY

If you believe the dishwasher is not working correctly, consult the quick guide provided
below with some practical tips on how to fix the most common problems. If the
malfunction continues or recurs, contact the Technical Assistance Centre.
BUG REPORTS
l
Models with a display: errors are reported by a number preceded by the letter "E"
(e.g. Error 2 = E2) and a short audio signal.
l
Models without a display: errors are reported by the indicator lights flashing on the
control panel.
Only models with a display
Error displayed
"CHECK WATER"
with a short audio signal
(only on some models).
E2
(with display) with a
short audio signal
E3
(with display) with a
short audio signal
E4
(with display) with a
short audio signal
E4-E6-E7-Ef-EL
(with display) with a
short audio signal
E8-Ei
(with display)
with a short audio signal
Only models without a display
If malfunctions or faults occur when a programme is running, the indicator light that
corresponds to the selected cycle will blink rapidly, and an intermittent audio signal will
sound. In this case, turn the dishwasher off by pressing the "ON/OFF" button.
After checking to make sure the water supply is open, that the drain pipe is not bent
and that the siphon or filters are not clogged, set the selected program again.
Meaning and solutions
The dishwasher does not fill with water
Make sure the water supply is open.
Make sure the water supply hose is not bent or crushed.
Make sure the drain pipe is at the proper height (see installation
section).
Close the water supply, unscrew the drain pipe from the back of the
dishwasher and check that the "sand" filter is not clogged.
The dishwasher does not drain water
Make sure the drain pipe isn't bent, trapped or blocked, and the filter
is not clogged.
Make sure the siphon is not clogged.
Water leak
Make sure the drain pipe isn't bent, trapped or blocked, and the filter
is not clogged.
Make sure the siphon is not clogged.
Electronic control fault.
Contact the Technical Assistance Centre.
The water heating element is not working correctly or the filter
plate is clogged
Clean the filter plate.
102