Programme End; Option Buttons - Candy CDIMN 4D622SB Mode D'emploi

WARNING:
Before starting a new programme, you
should check that there is still detergent
in the dispenser. If necessary, top up the
dispenser.
If there is any break in the power supply
while the dishwasher is operating, a
special memory stores the selected
programme and, when the power is
restored, it continues where it left off.
Programme operations
(only for free-standing models)
While a programme is running, the display
shows the time remaining to the end of the
cycle, which is automatically updated.

Programme end

A 5 second buzzer will sound (if not muted)
3 times at 30 second intervals to signal that
the programme has ended.
If the "SMART DOOR" feature is activated,
during the drying phase the door will
open automatically and you will have
to wait until for the end-of-cycle signal
before removing the dishes.

Option buttons

"SMART DOOR" button
(AUTOMATIC DOOR OPENING)
This option enables a special device that
opens the door by a few centimetres during
or at the end of the drying cycle (depending
on the programme). This ensures the
natural and efficient drying of dishes. The
duration of the
automatically change to obtain the optimal
temperature for the
significantly reduces energy consumption.
The door opening automatically during the
last drying phase enables the air to
circulate, removing the risk of bad odours.
selected cycle will
rinse cycle; this
This option is automatically enabled in
the "ECO" programme. In any case, it
is possible to disable it. The "SMART
DOOR" feature is not available in the
"ZOOM 39'", "RAPID 24'" and "PREWASH"
programmes.
"ALL-IN-1" button
This option optimises the use of "ALL in 1"
("3 in 1" / "4 in 1" / "5 in 1", etc.) combined
detergents. By pressing this button, the
selected wash programme is modified to
get the best
combined detergents. Furthermore, the "no
salt" and "no rinse aid" warning lights are
disabled.
WARNING:
Once selected, this option remains
enabled (indicator light on) for the
next wash cycles. It can only be
disabled (indicator
pressing the button again.
This option is recommended when
using the RAPID 24' programme, the
duration of which will be extended for
about 15 minutes,
detergent tablets to achieve a better
performance.
"No salt" warning light
If your dishwasher requires filling with salt,
the display will show and flash "SL" when
the dishwasher is switched on.
"START DELAY" button
Dishwasher start time can be set with this
button, delaying start from 1 to 23 hours.
Proceed as follows to set a delayed start:
l
Press the "START DELAY" button ("00" will
appear on the display).
95
performance from
light off)
allowing
the
by
the