De Dietrich 90x60 CUISINIERE SEMI PROFESSIONNELLE Guide D'utilisation page 31

Problem
Wh le gn t ng one of the burners all the
hob burner gn ters spark
After sett ng the knob to s mmer ng flame
pos t on - the flame d es or s too h gh
Flame s unstable
Parts made of sta nless steel ( nox) deve-
lop sta ns that cannot be removed w th the
use of standard cleaners
Smoke com ng out of the oven
Damaged power lead
Cook ng results are not what you expec-
ted
Ign ters fa l to gn te or not always gn te
the gas
Gas burners fa l to gn te
Flame d es after releas ng the knob
It s normal
When press ng the selected knob (w th an ntegrated gn t on dev ce) or the
gn t on button sparks are re-leased at all the burners .
– Avo d draughts n the k tchen,
– Call the fitter to adjust s mmer ng flame pos t on
– Check to make sure that the burner components are clean, dry and
placed correctly.
– Sta nless steel surfaces should be cleaned
and only w th the use of spec al sta nless steel cleaner.
– Open the w ndows to a r the k tchen,
– When the oven cools down, clean ts nter or.
– Use the dr p tray when gr ll ng foods.
In order to avo d hazards, damaged power lead should be exchanged
at the manufacturer's or by a spec al st serv c ng po nt, or by a qual fied
person.
The cook ng parameters g ven n the nstruct on manual should be tre-
ated as gu dance only. In pract ce, these parameters are dependable on
the we ght and cons stency of food, cook ng tray level, etc. Therefore, we
recommend mak ng a few tr als for your favour te foods and then wr t ng
down the opt mal t me and temperature.
– Check to make sure the cooker s connected to the electr cal ma ns.
– Clean and dry the gn ters and burner components.
– Check to make sure the burner caps and heads are placed correctly.
– Press on the burner cap and rub t aga nst the head by turn ng r ght
and left.
– Rub the gn ter electrode w th the use of hard brush or smooth file
– Check to make sure the rubber hose supply ng gas from the gas cyl n-
der s not squeezed.
– Check to make sure the gas ma n valve s open.
– Check to make sure the gas cyl nder s not empty.
– In case a new cooker has been nstalled or the gas cyl nder has been
replaced w th a new one, then t s necessary to repeat the gn t on
procedure unt l the gas reaches the burner.
– Check to make sure the nozzle or burner flame holes are not clogged
or flooded. If so, un-clog the nozzle hole us ng a p n or needle. Clean
the burner flame holes w th the use of brush, and then dry all compo-
nents.
Your cooker s equ pped w th a flame fa lure safety dev ce
– Where the gn t on dev ce s bu lt n the knob set the
me , press the knob and when the gas has gn ted keep t pressed
all the way n for another few seconds. .
Solut on
.
each t me they get so led
knob to large fla-