Tips - Durabase DB40LE985 Mode D'emploi

Tips

Screen Care: Clean the screen with a slightly damp,
soft cloth. Do not use abrasive solvents as they may
damage the coating layer of the TV screen. For
your safety, unplug the mains plug when cleaning
the set. When moving the TV, hold it properly from
the bottom part.
Image Persistence: Please note that ghosting may
occur while displaying a persistent image.LED TVs'
image persistence may disappear after a short time.
Try turning off the TV for a while.
To avoid this, do not leave the screen in still picture
for extended periods.
No Power: If your TV system has no power, please
check the main power cable and connection to the
mains socket outlet.
Poor Picture: Have you selected the correct TV
system? Is your TV set or house aerial located too
close to a non-earthed audio equipment or neon
lights, etc.? Mountains or high buildings can cause
double pictures or ghost images. Sometimes you
can improve the picture quality by changing the
direction of the aerial. Is the picture or teletext
unrecognisable? Check if you have entered the
correct frequency. Please retune the channels. The
picture quality may degrade when two peripherals
are connected to the TV at the same time. In such
a case, disconnect one of the peripherals.
No Picture: Is the aerial connected properly? Are
the plugs connected tightly to the aerial socket? Is
the aerial cable damaged? Are suitable plugs used
to connect the aerial? If you are in doubt, consult
your dealer. No Picture means that your TV is not
receiving a transmission. Have you selected the
correct button on the remote control? Try once
more. Also make sure the correct input source has
been selected.
Sound: You can not hear any sound. Did you perhaps
interrupt the sound, pressing the button? Sound is
coming from only one of the speakers. Is the balance
set to one extreme? See Sound Menu.
Remote Control: Your TV no longer responds to the
remote control. Perhaps the batteries are exhausted.
If so you can still use the local buttons on the TV.
Input Sources: If you cannot select an input source,
it is possible that no device is connected. Check
the AV cables and connections if you have tried to
connect a device.
English - 67 -