Riving Knife Alignment - Skil 3601 Consignes D'utilisation/De Sécurité

SM 2610029990 06-13_3601 6/21/13 12:16 PM Page 14
5. Remove the blade bolt and blade collar.
6. Remove blade by sliding it down through the kerf insert
and out through the underside of the table.
NoTe: Inner washer does not need to be removed.
7. Install a 4-3/8" (110mm) blade.
NoTe: Make sure the rotation arrow on the blade
matches the rotation arrow on the upper guard.
To avoid injury, do not use a blade larger or smaller than 4-
3/8" diameter and 3/4" arbor.
8. Install the blade collar in the proper orientation, then
install blade bolt. Tighten blade bolt finger tight. Press
the arbor lock and tighten blade bolt securely, but do not
overtighten.
9. Be sure the arbor lock is released so the blade turns
freely.
10. Close blade bolt cover, insert rear screw, and tighten.
After installing a new blade, check for any contact with the
base or table structure. If blade contacts table, seek
authorized service.

Riving Knife Alignment

See figures 6-7.
W RNING
adjustment or repair to avoid possible injury.
1. Remove the anti-kickback pawls.
2. Using a philips screwdriver, slightly loosen the two
screws which mount the riving knife to the blade guard.
3. Align the riving knife in line with the blade.
4. Re-tighten both riving knife screws.
Assembly and Adjustments
Disconnect plug from power source
before performing any assembly,
Blade Bolt
outer collar
FIG. 7
Riving
Knife
Screws
Riving Knife
14.
FIG. 6
inner collar
Blade
Align
Riving
Knife with
Blade