Care And Maintenance - LENCO BT-9000 Mode D'emploi

- Do not subject the unit to excessive force, shock, dust or extreme temperature.
- Do not tamper the internal components of the unit.
- Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
- Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
- Keep your unit away from heating appliances and sources of electrical noise such as luorescent lamps or motors.
If drop-outs or interruptions occur in the music during play, or if the disc fails to play at all, its bottom surface may
require cleaning. Before playing, wipe the disc from the center outwards with a good soft clean cloth.
Resetting the Unit
If the unit experiences a power surge or electric shock, it is possible that the internal micro-controller may lock up and
the unit will not respond to any commands from the panel controls.
1. In this event, unplug and then reconnect the AC power plug into the wall outlet.
2. Use a straightened paper clip, toothpick or similar objects to press the RESET button located at the rear of the
main unit (see the below igure). The reset operation clears the system memory and all of your previous settings
will be erased.
CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE RESET BUTTON.
IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT.
Note:
- In case of malfunction due to electrostatic discharge (ESD), just reset the product to
resume normal operation.
- The normal function of the product may be disturbed by Strong Electro Magnetic Interference. If so, simply reset
the product to resume normal operation. In case the function could not resume, please use the product in other
location.

Care and Maintenance

RESET Button
GB 12