LENCO BT-9000 Mode D'emploi page 10

CD Program Playback
This feature allows you to program up to 20 tracks for Audio CD or 30 songs for MP3 CD in a desired order.
1. With CD playback stopped, press the PROG button once from the remote control.
The LCD shows following indication:
"PGM" indicator
The program number (e.g. P01) blinks.
The Track number (e.g. T001)
The Directory (Folder) number (e.g. A01) ---- apply for MP3 disc only.
2. To select a directory number, press the FOLDER
To select a track number, press the
3. When desired track number displayed, press the PROG button to conirm entry.
4. To program up to 20 Audio CD tracks or 30 MP3 CD songs, repeat steps 2 and 3 until all desired tracks are
entered.
Or, to begin programmed playback, press the Play/Pause
5. To cancel programmed playback, press the STOP
Note:
● If you press the /
track in the program, which is not necessarily the previous / next track on the disc.
● The CD play modes function, "
manner as during normal CD playback (see CD Play Modes above).
ID3 Function
This function allows users to view the song information (if any) on the track (ile) that they are playing.
To enable this function:
1. During CD-MP3 playback, press the ID3 button. The information (e.g. artist name, song title) saved on the track
(ile) will be shown on the LCD display.
2. To turn off the ID3 function, press the ID3 button again.
Note:
● Only applicable for recorded MP3 tracks (iles) with ID3 tags.
● The unit supports ID3 tags in English characters only. It does not support any other languages.
When the unit is powered on (in Bluetooth, Aux-IN, Line1, Line2, CD, DAB Radio or FM Radio mode), you can press
the BASS + / - and TREBLE + / - buttons to adjust to the desired bass and Treble level.
The unit provides three sets audio input connector (AUX-IN / LINE-IN 1 / LINE-IN 2).
You can connect to three different external audio sources.
1. Connect an audio cable with 3.5mm stereo plug from an auxiliary audio device to the AUX IN jack of the unit. Also
RCA type audio connector can be connected to the LINE-IN 1 and LINE-IN 2 audio input jacks.
2. Press the STANDBY
3. To select auxiliary audio input, press the FUNCTION button from the main unit or the button LINE-IN / AUX IN
from the remote control. The "AUX-IN" / "LINE-IN 1" / "LINE-IN 2" indicator shows on display.
4. Turn on the external auxiliary audio device.
5. The volume can now be controlled through the unit.
Operate all other functions on the external device as usual.
Notes: Press the STANDBY
Don't forget to switch off the power of the external audio device as well.
Listening to CD Music
/ button.
button during programmed playback, the unit will skip backward / forward to previous / next
"repeat one track and "
Treble and Bass Settings
Listening to External Audio Source
button to turn on the unit.
button to turn off the unit when you inish listening.
/ button from the remote control (for MP3 disc only).
button, the "PGM" indicator stays on the display.
button twice.
" repeat all programmed track, work in the same
GB 10