Guarantee And Support - Philips sonicare HealthyWhite+ Mode D'emploi

ENGLISH
16
5 Holding the handle upside down, press the shaft down on a hard
surface. If the internal components do not easily release from the
housing, repeat step 3 until the internal components are released.
(Fig. 15)
6 Remove the rubber battery cover (Fig. 16).
7 Wedge the screwdriver between the battery and the black frame at
the bottom of the internal components. Then pry the screwdriver
away from the battery to break the bottom of the black frame
(Fig. 17).
8 Insert the screwdriver between the bottom of the battery and the
black frame to break the metal tab connecting the battery to the
green printed circuit board. This will release the bottom end of the
battery from the frame (Fig. 18).
9 Grab the battery and pull it away from the internal components
to break the second metal battery tab (Fig. 19).
Be aware of the sharp edges of the battery tabs so as to avoid
injury to your ingers.
10 Cover the battery contacts with tape to prevent any electrical
short from residual battery charge. The rechargeable battery can
now be recycled and the rest of the product discarded
appropriately.

Guarantee and support

If you need information or support, please visit www.philips.com/support
or read the separate worldwide guarantee lealet.
Guarantee restrictions
The terms of the international guarantee do not cover the following:
- Brush heads.
- Damage caused by use of unauthorised replacement parts.
Damage caused by misuse, abuse, neglect, alterations or
-
unauthorised repair.
Normal wear and tear, including chips, scratches, abrasions,
-
discolouration or fading.