JVC KW-DB60AT Manuel D'instructions page 18

Menu operations
Menu item
FADER *3*4
BALANCE *4
LOUD
(Loudness)
VOL ADJUST
(Volume adjust)
L/O MODE
(Line output
mode)
SUB. W *5
(Subwoofer)
SUB.W LPF *6
(Subwoofer low-
pass filter)
SUB.W LEVEL *6
(Subwoofer level)
HPF *6
(High-pass filter)
BEEP
(Keytouch tone)
TEL MUTING *7
(Telephone
muting)
AMP GAIN
(Amplifier gain)
*3 If you are using a two-speaker system, set the fader level to "00".
*4 This adjustment will not affect the subwoofer output.
*5 Displayed only when <L/O MODE> is set to <SUB.W>.
*6 Displayed only when <SUB.W> is set to <ON>.
*7 To activate this function, select <SRC SELECT>B<R-AUX>B<R-AUX ON>/<R-AUX OFF>.
18 | ENGLISH
Selectable setting (Initial: [XX])
R06 — F06 [00]: Adjusts the front and rear speaker output balance.
L06 — R06 [00]: Adjusts the left and right speaker output balance.
ON: Boosts low and high frequencies to produce a well-balanced sound at
a low volume level.
[OFF]: Cancels.
-05 — +05 [00]: Presets the volume adjustment level of each source,
compared to the FM volume level. Before adjustment, select the source you
want to adjust. ("VOL ADJ FIX" appears if "FM" is selected.)
Select if the LINE OUT cord on the rear panel are connected to the rear
speakers or subwoofer through an external amplifier.
SUB.W: Subwoofer
[REAR]: Rear speakers
OFF: Cancels.
[ON]: Turns on the subwoofer output.
LOW 55Hz/MID 85Hz/[HIGH 120Hz]: Audio signals with frequencies
lower than 55 Hz/85 Hz/120 Hz are sent to the subwoofer.
00 — 08 [08]: Adjusts the subwoofer output level.
ON: Activates the High Pass Filter. Low frequency signals are cut off from
the front/rear speakers.
[OFF]: Deactivates. (All signals are sent to the front/rear speakers.)
[ON]/OFF: Activates or deactivates the keypress tone.
ON: Mutes the sounds of the unit while using the mobile phone system
(not connected through Bluetooth adapter KS-BTA100).
[OFF]: Cancels.
LOW POWER: Limits the maximum volume level to 30. (Select if the
maximum input power of each speaker is less than 50 W to prevent
damaging the speakers.)
[HIGH POWER]: The maximum volume level is 50.