Clock And Alarms - Sangean RCR-20 Mode D'emploi

Clock and Alarms

Setting the time format
The clock display used in stand-by mode and on the playing mode screens can be set to 12 or 24
hour format. The selected format is then also used when setting the alarms.
1. Press and hold the Info/Menu button to enter the menu setting.
2. Rotate the Tuning control knob until "CLOCK XXH" appears on the display, then press and release
the Tuning control button to enter the setting and the setting of time format begins to flash.
3. Rotate the Tuning control knob to select either 12 or 24 hour format. Press and release the Tuning
control button to confirm your choice of clock format. The display will then revert to the previous
menu. If the 12 hour clock format is chosen, the radio will then use the 12 hour clock for the setting
of alarms with a PM indicator.
Setting the date format
1. Press and hold the Info/Menu button to access the menu setting.
2. Rotate the Tuning control knob until a date (e.g. JAN 1 FRI) shows on the display. Press and release
the Tuning control button to enter the date format setting.
3. Rotate the Tuning control knob to select the required date format. Press and release the Tuning
control button to confirm your choice of date format. The display will then revert to the previous
menu.
Setting the clock time and date
Your RCR-20 has two options to set up its clock time: FM Radio Data System (RDS) and Manual
setting.
GB
16