Sangean RCR-20 Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Playing a previously-paired Bluetooth source device
The RCR-20 can memorize up to 8 paired Bluetooth source devices,
when the memory exceeds this amount, the earliest paring device will be
over written from the device.
If your Bluetooth source device already paired with the RCR-20 previously,
the unit will memorize your Bluetooth Source device and will attempt to
reconnect with a Bluetooth source device in the memory that was last
connected. If the last connected Bluetooth source device is not available,
the RCR-20 will try to connect to the second last Bluetooth source device.
Deleting Bluetooth paired device memory
1. Press the Source button as needed to select Bluetooth mode.
2. To clear the memory of all paired devices, press and hold the Bluetooth
pairing button for more than 5 seconds until you hear a beep and the
"CLEARING" will show on the display.
Disconnecting your Bluetooth device
Press and release the Bluetooth pairing button to disconnect with your
Bluetooth device, you will hear a beep.
You can also press the Source button to select any mode other than
Bluetooth mode or turn off Bluetooth on your Bluetooth source device to
disable the connection.
If you disconnect the Bluetooth device when you are in Bluetooth mode,
the "BT PAIRING" will show on the display, indicating Bluetooth is
available again for pairing.
GB
14

Publicité

Table des Matières
loading

Table des Matières