Philips PowerTouch 5000 Série Mode D'emploi page 19

2 Press the on/off button on the Jet Clean
System to start the cleaning program.
The cleaning program has two phases, the cleaning
phase and the drying phase.
, The battery symbol on the Jet Clean System
goes out.
, During the first phase of the cleaning program,
the cleaning symbol starts to flash and the
shaver is automatically lowered into the cleaning
fluid.
, The shaver automatically switches on and off
several times and moves up and down.
, The cleaning symbol flashes throughout the
cleaning program, which takes approx. 8 minutes.
, During the second phase of the cleaning
program, the shaver is placed in the drying
position, indicated by a flashing drying symbol.
This phase takes approx. 4 hours. The shaver
stays in this position until the end of the program.
, After the cleaning program, the battery symbol
on the Jet Clean System goes on to indicate that
the shaver is being charged.
Note: If you press the on/off button of the Jet Clean
System during the cleaning program, the program aborts
and resets. In this case, the cleaning or drying symbol
stops flashing and the holder returns to its starting
position. The shaver may still be wet and dirty, because
the cleaning program has not been finished.
Note: If you remove the adapter from the wall socket
during the cleaning program, the program aborts. The
holder remains in its current position. When you put
the adapter back into the wall socket, the holder moves
to the highest position.
English
19