Philips PowerTouch 5000 Série Mode D'emploi page 18

English
18
1 Simultaneously press the release buttons on both
sides of the cleaning chamber (1). Then lift the
Jet Clean System off the cleaning chamber (2).
, The cleaning chamber remains behind.
2 Unscrew the cap from the bottle with HQ200
cleaning fluid and remove the airtight seal.
3 Fill the cleaning chamber with HQ200 cleaning
fluid up to the MAX indication.
Note: Make sure the cleaning chamber is always filled
above the MIN indication.
4 Place the Jet Clean System back onto the
cleaning chamber ('click').
Make sure that the release buttons snap back into
place.
When the cleaning chamber is filled with
cleaning fluid, do not move it to prevent leakage of
cleaning fluid.
5 Put the small plug in the Jet Clean System and
put the adapter in the wall socket.
, The holder automatically moves to the highest
position.
The Jet Clean System is now ready for use.
Using the Jet Clean system
1 Place the shaver without protection cap upside
down in the holder. Push down the locking
lever completely to lock the shaver into place.
, The battery symbol on the Jet Clean System goes
on to indicate that the shaver is being charged.
Note: The shaver cannot be placed in the Jet Clean
System when the protection cap is on the shaving unit.