Klarstein 10029702 Mode D'emploi page 23

Put the drainage pipe into drainage port and screw
it up, and then bind it with pipe hoop.
Put the rubber plug into the other siede of draina-
ge pipe, fix it with pipe hook and then fix it in the
drainage pipe clip.
Drainage way as follows
In cooling or drying operation, the condensation water will be drained to the chassis and spattered by water-
striking motor. As the temperature of condenser is high, most of the condensation water will be evaporated
and drained to outdoor. So usually, only a little condensation water will be accumulated inside the chassis and
you do not need to discharge the water frequently. When the chassis is full with water, the buzzer will give out
8 sounds and „H8" is displayed to remind user to discharge water:
• Move the unit to a suitable place for discharging water; do not tilt the unit and keep it horizontal during moving;
• Take the drainage pipe from the clip and pull out the rubber plug on the drainage pipe to discharge water;
• After full water protection is eliminated and the compressor has been stopped for 3 minutes, the unit will
resume operation.
Using a continuous Drainage
Water can be automatically emptied into a floor drain by attaching 14mm inner diameter hose (not included).
Remove the continuous drain
cap 1 by turning it counter clock-
wise then remove the rubber
stopper 2 from the spout.
23
Screw the drain connector
to(included in the package) the
spout by turning clockwise.
Insert the drainage hose into
drain connector.