Before Startup; Charging Battery; Operation - Kärcher BD 38/12 C Bp Manuel D'instructions

1 Dosage cleaning solution
2 Switch for detergent solution
3 Control lamp to apply detergent so-
lution
4 Indicator lamp vacuuming
Green: Suction turbine in operation
Orange, flashing: Suction turbine
overloaded
5 Indicator lamp brush drive
Green: Brush is rotating
Orange, flashing: Brush overloaded
6 Battery status display
Green Battery charged
Orange: Battery almost empty
Red Appliance swithces off: Load
battery
7 Indicator lamp Eco mode
8 Switch Eco mode
9 Power switch

Before Startup

Charging battery

Note:
The device is equipped with a safety
mechanism to prevent total discharge,
i.e. when the permissible minimum ca-
pacity is reached, the machine will be
shut off.
The charging process takes approx. 3
hours.
The charger automatically switches off
the charging process.
If necessary, the appliance can be
used again before the battery has been
fully charged.
Insert the mains plug into the sock-

et.
Battery charging display
1 Battery is charged (green)
2 Battery is being charged (yellow,
flashing)
3 Malfunction (red)
Release the star knob for the trans-

port position.
Adjust the push rod to the desired

height.
Tighten the star handle.

Install the disc brush (see "Mainte-

nance and Servicing")
Filling in detergents
ATTENTION
Risk of damage. Only use the recom-
mended detergents. With other deter-
gents, the operator bears the
increased risk regarding the operation-
al safety, risk of accident and reduced
service life of the appliance. Only use
detergents that are free of solvents, hy-
drochloric acid and hydrofluoric acid.
Follow the safety instructions for using
detergents.
– 7
EN

Operation

9