Using Your Digisender; Standard Operation - DigiSender Plug'n'Go LCD Série Mode D'emploi

DX2000-LCD - DigiSender® Plug'n'Go™ LCD - Single Input 5.8GHz Wireless AV Sender System
Using your DigiSender®

Standard Operation

The steps below should be followed every time you use the DigiSender®.
1.
Switch on the source equipment (Satellite, Free-
view, DVD, VCR, etc.).
3.
On the receiving TV, select the SCART channel
assigned to the SCART socket that you plugged
the Receiver in to. This may be labelled as SCART,
AUX, AV, VIDEO, VCR or
Please read the instructions carefully prior to installation
.
2.
If you have not already done so, turn on both the
Transmitter and Receiver by pressing the power
button on the front of the units.
4.
When controlling your source device from the re-
ceiving location, point your remote control at the
IR Sensor you attached to your TV. Ensure you
are you using the correct remote control for your
source device.
ENGLISH (UK)
Page 07