Install The Digisender® X7 Transmitter Unit - DigiSender X7 Mode D'emploi

DG440 - DigiSender® X7
STEP 2
Install the DigiSender® X7 Transmitter Unit
The transmitter unit is designed to send video and sound from one of up to 4
connected sources to a receiver somewhere else in your home.
STEP 1
Place the DigiSender® transmitter on a flat
surface near to your source equipment. Avoid
placing the transmitter directly on top of other
electrical devices (see troubleshooting guide)
STEP 3
Connect DigiConnector™ 2 into your VCR or
DVD. Where available, use SCART sockets labelled
OUT or TV. Connect any existing SCART lead in to
the rear socket of the DigiConnector™
Page 6
STEP 2
Connect DigiConnector™ 1 into your satellite or
cable receiver. Use the SCART socket labelled 'TV'
and connect any existing SCART lead (if present)
into the rear (socket) of the DigiConnector™.
What's the
The Contrast A/B
switch is present
to compensate
for differences in
equipment/set-
ups.
Once installation
is complete, if
you experience a
poor picture then
adjust the A/B
setting.
Online Support at www.digisender.net
A/B
switch for
??