DigiSender X7 Mode D'emploi page 7

continued...
Avoid positioning the transmitter near to 2.4GHz wireless enabled devices
such as modern games consoles, wireless controllers, laptops, DECT phones
or wireless networking equipment.
STEP 4
Ensure that both the A/V Channel and IR
Channel are set to 1.
See the trouble shooting sections for further
information on the channel selection process.
STEP 6
Connect the power supply unit to the socket
labelled PSU.
Please read this instruction manual carefully prior to installation
STEP 5
Connect the IR Systeme Technik™ IR Emitter to
the socket labelled IR on the rear of the
transmitter. Follow the steps overleaf to install the
IR Systeme Technik™ IR Emitter.
STEP 7
Connect the power supply unit (PSU) into an
available wall socket.Press the POWER button on
your DigiSender remote control to switch the
transmitter on.
ENGLISH
DG440 - DigiSender® X7
Page 7