Remote Relay Problems; Troubleshooting Guide - DigiSender Plug'n'Go LCD Série Mode D'emploi

ENGLISH (UK)
DX2000-LCD - DigiSender® Plug'n'Go™ LCD - Single Input 5.8GHz Wireless AV Sender System
Troubleshooting

Remote Relay Problems

If you have any difficulty operating your source equipment remote control in your second room
please follow the advice below below:
1. Ensure the IR Emitter is connected to the socket labelled 'IR' on the Transmitter.
2. Ensure you are using the correct remote control in the second room. For instance, if you are trying
to control your Satellite box you will need to use the Satellite remote control.
3. Ensure the IR Emitter is facing the IR sensor on your source equipment.
4. Move the IR Emitter further away from the source equipment.
5. Move the Transmitter AND Receiver further away from other electrical devices.
6. Try operating your source remote control closer to the Receiver.
7. Replace the batteries in your source remote control.
8. Try attaching the IR Sensor to another part of your receiving TV. Sometimes the TV can put out a
bit of interference which can stop the IR Sensor from working properly.
Page 12
WATCH A VIDEO
WATCH A VIDEO
INSTALLATION
INSTALLATION
& TROUBLESHOOTING GUIDE
& TROUBLESHOOTING GUIDE
Available online at: www.aei.eu/video
Available online at: www.aei.eu/video
Please read the instructions carefully prior to installation