Beta 960TP Mode D'emploi page 13

OIL PRESSURE TEST (adaptors 960 PO/TP)
When you select "Oil pressure test", the tester will be ready to test oil pressure. By default the
maximum reading will be shown on the display.
You can toggle between maximum and actual reading using the right arrow.
The maximum reading can be cleared using the left arrow.
The maximum reading is stored even if the display shows the actual reading; you just need to press
the right arrow to check the stored maximum reading.
ENGINE COMPRESSION TEST (adaptors 960 CB/TP petrol)
When you select "Petrol compression" or "Diesel compression", the tester will be ready to test the
compression, and the following display will be shown.
You can select the right cylinder using the up and down arrow. The selected cylinder will be shown,
and the maximum reading will be stored automatically. Use the left arrow to clear the reading of the
selected cylinder.
Pressing the right arrow you can toggle between graphical and text display.
The graphic bar will represent 0 to 10 bar when you test petrol compression and 0 to 80 bar when
testing diesel compression.