Put Parking Cooler Into Operation; Advanced Settings - Webasto Cool Top Vario 10 E Notice De Montage

Cool Top Vario 10 E
10. Align the parking cooler on the inside roof trim of
the vehicle. This can vary depending on the
vehicle model.
11. Position the mounting bars on the screw bolts so
that the greatest possible contact surface is
provided at the front and rear. The mounting
bars must be mounted between the inside roof
trim and the roof skin.
12. Screw four self-locking nuts with washers onto
the studs and tighten diagonally with 5 Nm.
13. Connect the power supply cable to the parking
cooler.
14. Position spacer sleeves on all four screw bolt of
the parking cooler.
14.1. For Renault Premium: Two spacer sleeve
are positioned on the front screw bolts of
the parking cooler.
14.2. For Scania: No spacer sleeves are used.
15. Place the interior trim provided on the studs and
screw it on with four plastic nuts.
15.1. For Volvo: Use four M8 screws. Mount
cover caps on the screw heads.
16. Connect the power supply cable to the fuse box
in the passenger footwell.
17. Connect the batteries and conduct an operating
test.
CAUTION
If the Cool Top Vario 10 E parking cooler is
tilted by more than 30° out of the normal
position, at least 2 hours must be waited
before switch-on. Otherwise, a malfunction
can occur.
3.4

Put parking cooler into operation

For information on start-up and operation of the parking
cooler, see the operating instructions.
3.5

Advanced settings

The advanced settings enable adjustment to special
environmental conditions (F1, F2, F3, F4, F5) and service
settings (F6, F7, F8).
The service menus (F6, F7, F8) should only be changed by
trained service personnel.
The following advanced settings are possible:
• F1
Setting of the switch-off limit for low battery
voltage
• F2
Setting of the switch-on limit for low battery
voltage
• F3
Setting of the minimum display brightness
• F4
Setting of the maximum display brightness
• F5
Controller offset = temperature difference
between target and actual temperature (six 1 °C
steps).
• F6
Memory for communication status of parking
cooler.
• F7
Memory for operating status of parking cooler.
• F8
Factory settings
To access the Settings menu:
1. Briefly press the On/Off button on the control
panel to access the stand-by mode.
2. Press the Temperature + and Temperature –
buttons on the control panel simultaneously.
3. The Settings menu is active. F1 appears on the
display.
To change between the settings F1 to F9, press the
Temperature + or Temperature – button on the control
panel. Then activate the desired setting by pressing the
Timer button on the control panel.
To change the value of the selected setting, press the Fan +
or Fan – button on the control panel.
3 Installation
15