Selecting The Setup Site For The Duratec Pos S15 - Duratec POS S15 Mode D'emploi

Damage to the POS system
a
components caused by unsuitable
setup site.
Observe the information in chapter
X
3.1.1 "Selecting the setup site for the
Duratec POS S15" on page 27.
• Put the Duratec POS S15 onto the stand.
Damage to the power supply unit
and the POS system caused by
excessively high voltages or currents.
a
Use the provided power cord.
X
Use an earthed socket to which
X
alternating current between 110 and
240 volts is connected.
Use power sources which are
X
protected with a residual-current
circuit breaker.
• Insert the safety plug of the power cord to a socket.
NOTICE
NOTICE
D
EN
29