Notes On Safety - Duratec POS S15 Mode D'emploi

2. No t e s on s a f e t y
Deadly shock caused by damaged POS system
components.
X
X
Deadly shock caused by improper repairs.
Some components can contain high residual voltages
which discharge when touched.
X
X
Pinching of fingers when aligning the screen.
The gap between the screen housing and the joint
changes during alignment.
X
X
Danger of tripping and damaging device caused by
device cables lying unprotected in the room.
X
A DANGER
Disconnect the mains cable from the power grid in
case of damage.
Contact your Vectron specialist retailer if POS
system components are damaged.
Disconnect the mains cable from the power grid in
case of damage.
Contact your Vectron specialist retailer if POS
system components are damaged.
A CAUTION
Do not insert your fingers between the screen
housing and the joint.
See in chapter 3.2 "Adjusting the display" on page
31 before aligning the screen.
Route the device cables so that they do not pose a
potential hazard!
D
EN
25