Duratec POS S15 Mode D'emploi page 26

Dur at e c P O S S15
26
Damage to the POS system components caused by
unsuitable installation location.
Observe the information in chapter 3.1.1
X
"Selecting the setup site for the Duratec POS S15"
on page 27.
Damage to the power supply unit and the POS
system caused by excessively high voltages or
currents.
Use the mains cable provided.
X
Use an earthed socket to which alternating current
X
between 110 and 240 volts is connected.
Use power sources which are protected with a
X
residual-current circuit breaker.
Malfunctions caused by faulty programming.
Protect the programming and programming
X
functions with passwords.
Only change the programming when your are
X
absolutely sure of the effects this will have.
Your Vectron specialist retailer will support you
X
should you have questions on programming or
will program the POS system according to your
requirements.
Damage to the POS system components caused by
unsuitable cleaning agents
Cleaning agents can chemically react with the
surface materials.
Never use caustic cleaning agents to clean the POS
X
system or the power supply unit.
Damage to POS system components when
transporting in unsuitable packing.
Only transport the POS system and the power
X
supply unit in the original packing.
NOTICE
D