Drawing Up Lower Thread; Remontée Du Fil De La Canette - Brother XL-6562 Manuel D'instructions

Table des Matières

Publicité

1
2
Remontée du fil de la canette
1. Tenir légèrement l'extrémité du fil supérieur et imprimer lentement un
tour au volant manuel l'avant (anthoriaire) pour abisser et relever
l'aiguille.
2. Tirer sur le fil supérieur pour remonter le fil inférieur.
3. Tirer environ 10 cm (4") des deux fils et les placer vers l'arrière de la
machine, sous le pied-de-biche.
1 Fil supérieur
2 Fil inférieur
35

Drawing Up Lower Thread

1. While lightly holding the end of the upper thread, slowly turn the
balance wheel to the front (counter-clockwise) once by hand to
lower and then raise the needle.
2. Pull on the upper thread to draw up the lower thread.
3. Pull out about 10 cm (4") of both threads and place them toward
the back of the machine under the presser foot.
1 Upper thread
2 Lower thread
txt_Sp
Levantar el hilo inferior
1. Coja con suavidad el final del hilo superior y dé con cuidado una
vuelta con la mano a la ruedecilla hacia delante (hacia la
izquierda) para bajar la aguja.
2. Tire del hilo superior para levantar el hilo inferior.
3. Saque unos 10 cm de ambos hilos y colóquelos en dirección a la
parte trasera de la máquina, debajo del prensatelas.
1 Hilo superior
2 Hilo inferior

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Xl-6452Xr-46

Table des Matières