Roco smartRail Manuel D'utilisation page 55

1 Main switch Equivalent to F1 and switches the locomo-
tive sound on.
2 Combined brake In the original, the left lever operates the
air brake and the right one the e-brake.
The control stand has a combined brake.
3 Train power The higher the value, the faster the train
setting lever will accelerate. The value is set on the
train power display (6).
4 ADB lever
If you push the ADB lever (4) forward the
orange pointer in the speedometer (5)
moves and displays the set speed.
5 Speedometer The black pointer shows the current
speed in km/h. The orange pointer shows
the set speed.
6
Train power display / The train power display/brake force
brake force display display shows the current acceleration /
braking force.
7 Direction switch Used to change direction. Can only be
operated during standstill.
smartRail-Gebrauchsanleitung_19.11.indd 55
8 Light switch Switches the function "F0".
(switch front = ON)
9 Switch high beams Switch position back means "High
beams OFF". Position in the middle
means "High beam f% ON".
10 Switch for horn Horn 1 = high, horn 2 = low.
11 Emergency Stops the locomotive immediately
stop switch
12 Compressor Switches function key F13.
13 Drive motor fan Switch position front means "Fan on".
Since fan and compressor run automa-
tically, the switch is not assigned to a
function.
14 Current collector Switch position front means "Lift coll-
ector", rear means "Lower collector".
Button without function key.
15 Door opener Button without function key.
Operation with Z21 control stand app
55
19.11.2012 11:04:04