Fault Messages - HP LineJet Série Guide De Référence Rapide

Fault Messages

When a fault condition occurs, the status indicator flashes, the
alarm sounds, and a specific message appears in the display.
When this happens, correct the fault immediately.
You can correct most faults by performing a simple procedure, such
as clearing a paper jam or reloading paper. The following pages list
common fault messages and explain how to correct the fault
conditions.
For more serious faults, indicated by an asterisk (*) following the
fault message, a Hewlett-Packard Customer Service Engineer will
be needed. For error messages not covered in this guide, refer to
your Maintenance Manual.
Note Faults indicated by an asterisk (*) prevent further printer
operation, and the printer power must be turned off to clear the
fault.
Perform the following steps to clear a fault message after you have
corrected the fault condition:
1.
Press CLEAR, then ON LINE to continue printing.
2.
If the fault message reappears, turn the printer power off, wait
15 seconds, then turn the printer back on. Run your print job
again. If the message does not reappear during printing, no
further attention is required. If the fault message reappears, go
to step 3.
3.
Press ON LINE again and resume printing. If the message
does not appear, no further attention is required. If the
message reappears, call your Hewlett-Packard Customer
Service Engineer.
Fault Messages
85