What If There Are Problems; Technical Data - Beurer ELLE FCE80 Mode D'emploi

8.

What if there are problems?

Problem
The device does not
respond after switching
on.
The green LED is
flashing.
Fault during battery
charging. After putting
the device on the
charger, the red LED
does not light up.
The device is not fully
charged after 2 hours.
The red LED is lit.
9.

technical data

Dimensions (diameter x h)
Mains voltage/frequency
Battery
Battery life
Signs and symbols
Cause
Is the battery flat?
Is the battery almost flat?
Is the power supply unit not plugged in
correctly?
Is the plug on the mains cable not
correctly inserted into the charger?
Is the device not correctly positioned on
the charger?
Are the battery contacts of the device and
charger dirty?
Is the device being used for the first time?
Has it been six months or more since the
device was last used?
Approx. 7 cm x 17.5 cm with charger
100-240 V / 50/60 Hz
NiMH
Approx. 20 minutes per charge, life cycle approx. 500 charges
The unit is double-protected and thus corresponds to protection
class 2.
Solution
> Charge the battery
w Initial use
w Charging the battery
> Charge the battery
w Initial use
w Charging the battery
> Plug the power supply unit into
the mains socket
> Insert the plug into the back of
the charger
> Remove the device and replace it
on the charger. The charger must
be standing up straight and the
device may not tip over.
> Using a lint-free cloth, clean
the contacts of the charger and
device
> If the battery has been
particularly heavily discharged,
charging can take longer than 2
hours
20