Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When the lock lever is in the locked position
switch cannot be actuated.
When the lock lever is in the unlocked position
switch can be actuated.
Switch action
CAUTION:
•
Before inserting the battery cartridge into the
tool, always check to see that the switch actu-
ates properly and returns to the "OFF" position
when released.
1
2
► 1. Lock lever 2. Switch
To start the tool, first move the lock lever to the
unlocked position
to release the switch lever.
A
B
► 1. Switch
And then turn the switch to A side for clockwise rotation
or to B side for counterclockwise rotation.
Tool speed is increased by increasing rotation force on
the switch. Release the switch to stop.
CAUTION:
•
Always check the direction of rotation before
operation.
•
Change the direction only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the
tool.
•
When not operating the tool, always set the lock
lever in the locked position
Lighting up the front light
CAUTION:
•
Do not look in the light or see the source of light
directly.
, the
, the
B
A
1
.
1
► 1. Lock lever 2. Light
To start the tool, first move the lock lever to the released
position
to release the switch.
A
B
► 1. Switch
To put on the light only, rotate the switch to the A or B
side a little.
To not only put on the light but also start the tool rotate
the switch to the A or B side more.
Release the switch to stop the lamp and tool.
NOTE:
•
Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
ASSEMBLY
CAUTION:
•
Always be sure that the lock lever is in the
locked position
tridge is removed before carrying out any work
on the tool.
5 ENGLISH
2
B
A
1
mark and the battery car-
Publicité
Table des Matières
