Quick-Menu Parameters - AERMEC NXW Série Manuel D'utilisation

QUICK-MENU parameters

MAIN MENU - QUICK MENU - Cooling circuit information
Visualisation on unit display
A
Circuit 1
B
HP1: 12.0barg 15.9 C
C
LP1: 14.0barg
D
Comp1:ON
E Comp2:OFF
MAIN MENU - QUICK MENU - General regulation settings
Visualisation on unit display
A
Unit
B
Current set:
C
Regul.temp.:
D
Step required: 01/02
Index
A Circuit number: Indicates to which cooling circuit the data
displayed refers to.
B High pressure: Indicates the high pressure value measured
on the cooling circuit; this data is expressed in (bar) but the
corresponding temperature data is also displayed.
C Low pressure: Indicates the low pressure value measured on
the cooling circuit; this data is expressed in (bar) but the cor-
o
responding temperature data is also displayed.
21.1 C
o
D/E Compressor 1/2 state: Indicates the state of the compres-
sor 1 (of the circuit to which it refers), this state can be one of
the following:
ON = compressor ON;
OFF = compressor OFF;
OFF alarm = compressor off due to alarm;
OFF stand-by 180s = compressor request but cannot switch-
on due to safety times;
OFF stand-by 180s = compressor request but cannot switch-
on due to safety times;
Index
A Unit: Indicates the general parameters with which the unit is
set.
B Current set point: Indicates the value currently set as work
set point.
o
12.0 C
C Regulation temperature: Indicates the temperature detected
o
16.8 C
by the probe used (this probe can vary on the basis of the type
of functioning).
D Partialisation steps requested: Indicates haw many compres-
sors are on instant by instant.
Display/Parameter
Display/Parameter
7