Qilive Q.6326 Manuel D'utilisation page 18

4.3. LEVELLING THE WASHING MACHINE
EN
Warning!
■ The lock nuts on all four feet must be screwed tightly against the housing.
1. Check if the legs are securely attached to the housing. If not, turn them to their
original positions and tighten the nuts.
2. Loosen the lock nut and turn the foot until it is in close contact with the floor.
3. Adjust the legs and lock them with a spanner, making sure that the machine is
steady.
4.4. CONNECTING THE WASHING MACHINE
4.4.1. CONNECTING THE WATER SUPPLY HOSE
Warning!
■ To prevent leakage or water damage, follow the instructions in this chapter!
■ Do not bend, crush, modify or sever the water inlet hose.
■ If the model is equipped with a hot valve, connect it to the hot water tap with the
hot water supply hose. Energy consumption will decrease automatically for some
programs.
Connect the inlet pipe as indicated (connection between screw tap and inlet hose).
Connect the other end of the inlet pipe to the inlet valve on the rear of the product and
fasten the pipe tightly in a clockwise direction.
Raise
Tap with thread and inlet hose
water Inlet valve
Lower
water supply hose
18
Lock nut
foot