Maintenance - Earlex HV2501EU Manuel D'instructions

EN
cover (2). Remove the diaphragm (3). Clean all the parts carefully.
Never hold the spray gun rear part under water or immerse it into liquids.
Clean the housing only with a moistened cloth.
12) Clean the outside of the spray gun and container with a cloth soaked in solvent or
water.
13) Remove the adjustment ring (fig. 11, 1) carefully from the union nut (2).
14) Unscrew the union nut (fig. 11, 2) and remove the air cap (3) and nozzle (4). Clean the
air cap and nozzle with a brush and solvent or water.
Assembly
The unit may only be operated with an integer diaphragm (Fig. 10, 3).
•
Place the diaphragm (Fig. 10, 3) with the pin facing upwards on the bottom section of
the valve. Also see the marking on the gun body.
•
Place on the valve cover (Fig. 10, 2) and screw it closed.
•
Place the ventilating hose (Fig. 10, 1) on the valve cover and on the nipple at the gun
body.
Attention! Never operate the device if the nozzle seal is either damaged or
missing. If the nozzle seal is either missing or damaged liquids can enter
the device and increase the risk of an electric shock.
•
Push the nozzle seal (fig. 12, 5) over the needle (6); the groove (slot) should point towards
you.
•
Place the nozzle (fig. 12, 4) on to the gun body with the recess facing downwards. Attention:
Position of needle must be congruent with the nozzle aperture. (Fig.13)
•
Put the air cap (Fig. 14, 3) onto the nozzle (4) and tighten it using the union nut (2).
•
Position the adjustment ring (fig. 15, 1) on the union nut so that the recesses on the
adjustment ring can snap into both horns on the air cap.
•
Place the container seal from below on the suction tube and slide it over the collar, while
turning the container seal slightly.
•
Insert the suction tube with container seal in the gun body.

16. Maintenance

WARNING! Never operate the machine without the air filter; dirt could
•
Change the air filter if it is soiled (Fig. 16).
•
In order to mount the gun more easily apply lubricating grease (enclosed) liberally
to the O-ring at the gun front part. (Fig. 17, 6)
10
be sucked in and interfere with the function of the machine.
Disconnect plug before changing parts.
HV2501EU