Wall Mounting - S&P TLS-401 Notice D'utilisation

maged, it should only be repla-
ced in one of our repair Works-
hops or by qualified staff in order
to avoid a dangerous situation.
- Inflammable objects must not be
left within 50 cm of the hot air
circuit (curtains, etc.).
- If the convector is installed per-
manently, the minimum distan-
ces indicated in Fig. 1 must be
respected.
- on no account must any switch
/ button be accessible by people
in the shower or in the bathtub.
- Whenever it is installed perma-
nently, the convector must be
situated so that the plug is ac-
cessible.
WArNING!! before starting the
convector, ensure that the base is
fitted correctly.
- Always keep the air inlet and
outlet grilles clean. Make sure
the convector is disconnected
when cleaning is carried out.
- Do not place the convector next
to a wall made of combustible
materials (wood, plastic, etc.).
- This appliance is not intended
for use by persons, including
children, with reduced physi-
cal, sensory or mental capabi-
lities, or lack of experience and
knowledge, unless they have
been given supervision or ins-
truction concerning use of the
appliance by a person responsi-
ble for their safety.
- Children must be under watch to
avoid that they could play with
the product.
- This appliance must not be used
connected to a programmer, timer
or another device that controls
heater connection automatically.
INSTALLATIoN
Before starting the convector, the
base must be fitted or the device
must be mounted on the wall.
FITTING THE bASE
Fit the base supports to the sides
(Fig. 3) and secure each one with
three screws. To remove the base
supports, loosen the screws and pull
the supports outwards.

WALL MouNTING

Wall mounting is only possible when
the base supports are not fitted.
Once you have chosen the location,
before fixing the convector to the
wall, make sure that the minimum
distances are respected (Fig. 1).
Proceed to mark and fix the upper su-
pports to the wall (Fig. 4, C). Once the
convector is mounted, immobilise it
with the lower support (Fig. 4, D and E).
SWITCHING oN AND oPErATIoN
Once you have checked that the
mains voltage coincides with the
voltage indicated on the name plate,
connect the convector.
9