Table des Matières
Publicité
The saturation indicator of the charcoal filter is normally disabled. To activate it, proceed in the
following manner:
With the display on (ON) and the suction off (OFF), press simultaneously the buttons T8 and T9
for more than 3 seconds; the button T9 lights on with steady light for approx. 5 seconds, to indi-
cate the activation.
To disable it, repeat the operation; the button T9 will flash for approx. 5 seconds to indicate the
disabling.
Setting of Automatic Operation parameters
For correct use of the automatic operation, perform "Hood Calibration".
Hood Calibration
With the display on (ON) and the suction off (OFF), press button T3 for 3 seconds.
The suction speed (power) 1 starts functioning and button T3 flashes to indicate that hood calibration
is initiated and it will last for approx. 5 minutes.
Note: to interrupt the calibration, press T3 for 5 seconds; the calibration will be invalidated and should
therefore be repeated.
MAINTENANCE
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical
supply by switching off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed
from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry
out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neu-
tral liquid detergent. Do not use abrasive products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replace-
ment of the filters may cause fire risks. Therefore, we recommend observing these instructions. The
manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inap-
propriate maintenance or failure to observe the above safety recommendations.
Grease filter
Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short
cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its
filtering capacity. To remove the grease filter, pull the spring release handle.
Charcoal filter
(filter version only)
It absorbs unpleasant odours caused by cooking. The saturation of the charcoal filter occurs after more
or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease
filter. In any case it is necessary to replace the cartridge at least every four mounths.
Replacing lamps
The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an opti-
mum lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical
energy.
For replacement, contact the technical service.
EN 33
Publicité
Table des Matières
