Treatment Of Submerged Motor - Yamaha Motor F75 Manuel De L'utilisateur

1
1. Fuel filter
6. Unscrew the filter cup, and then remove
the O-ring from the filter cup. NOTICE:
Be careful not to twist the water de-
tection switch lead when unscrewing
the filter cup.
[ECM01961]
1
2
3
1. O-ring
2. Filter cup
3. Water detection switch lead
7. Drain the water in the filter cup by soak-
ing it up with a rag.
8. Put the O-ring on the filter cup in its orig-
inal position, and then install the filter cup
onto the filter housing. NOTICE: Be
careful not to twist the water detec-
tion switch lead when screwing the fil-
ter cup onto the filter housing.
9. Fit the fuel filter into its holder.
10. Connect the water detection switch cou-
pler securely until a click is heard.
11. Fasten the water detection switch lead
with the holder.
12. Install the top cowling.
13. Turn the main switch to the "
sition and check that the water separa-
tor-alert indicator remains off and the
buzzer does not sound. If the water sep-
arator-alert indicator blinks or the buzzer
sounds, have your Yamaha dealer check
the outboard motor. NOTICE: Although
ZMU08706
the buzzer will stop when the engine is
started and the remote control lever is
moved to the forward or reverse posi-
tion, do not use the outboard motor.
Otherwise, serious engine damage
could occur.
EMU33502

Treatment of submerged motor

If the outboard motor is submerged, immedi-
ately take it to a Yamaha dealer. Otherwise
some corrosion may begin almost immedi-
ately. NOTICE: Do not attempt to run the
outboard motor until it has been com-
pletely inspected.
ZMU08707
[ECM01971]
Trouble Recovery
[ECM02391]
[ECM00402]
" (on) po-
97