Message List - Roland RP401R Mode D'emploi

°

Message List

Indication Meaning
E.01
The music file you attempted to save is read-only. It cannot be saved.
An error occurred while writing. It may be that the protect tab of the
E.02
external media is in the "Protect (write prohibit)" position, or that the
external media has not been formatted.
No USB flash drive connected. Connect a USB flash drive and try the
E.10
operation again.
There is insufficient free space at the save destination. Either connect a
E.11
different USB flash drive, or delete unwanted data (song data) and try
the operation again.
An error occurred while reading. The USB flash drive may be damaged.
E.14
Connect a different USB flash drive and try the operation again. You may
also format the USB flash drive (p. 7).
The file could not be read. The data format is not compatible with the
E.15
unit.
The data could not be read fast enough during song playback. After
E.16
waiting several seconds, you may be able to play back the song by
pressing the [s] button once again.
This audio format is not supported. Please use WAV format, 44.1 kHz,
E.18
16-bit linear audio files.
E.30
The unit's internal memory is full.
The unit cannot deal with the excessive MIDI data sent from the external
E.40
USB MIDI.
Reduce the amount of MIDI data sent to the unit.
The access point is not supported. Please use WPA or WPA2 authentica-
E.46
tion.
There may be a problem with the system.
E.51
Repeat the procedure from the beginning. If it is not solved after you
have tried a number of times, contact the Roland service center.
The USB flash drive connector was subjected to excessive current.
E.65
Make sure that there is no problem with the external media, then turn
the power off, then on again.
- - -
The Panel Lock function is on (p. 9).
PU
When playing back a song, this is shown if the song starts on an upbeat.
Blinking When the Auto Off function is activated, the remaining time blinks
number before the power turns off.
17