TECO 100 Variant Manuel D'utilisation page 35

- An effective manual wheel clamping system (Standard version) or pneumatic (AL version) which
makes use of the rim central hole by means of handle and cones (an optional clamping kit is supplied
for rims with no central hole).
- A pneumatic bead breaking unit consisting of two bead breaker disc holders. Its pneumatic vertical
movement is independent and activated from the console; the disc horizontal positioning is manual,
mechanically or pneumatically activated from the console and it allows the simultaneous positioning
of the bead breaker discs. The upper bead breaking arm could be unlocked by means of the manual
hook, thus performing an independent withdrawal movement for free working area access. The
success of the bead breaking activity is ensured by a specific disc penetration movement controlled
by an on-purpose control. The disc release is automatically driven by the reverse movements of
the bead breaker arms (upwards for the upper arms, downwards for the lower one).
NOTE:
The disc of the upper bead breaking arm can be manually rotated of 180° during the dismounting
of the lower bead on particularly large reverse rim wheels.
- A head, installed on a mobile column with lateral tilting system, consists of a fixed supporting
nucleus that facilitates tyre mounting and a pivoted mobile fixed nucleus that facilitates an optimal
tyre demounting without using the bead lifter lever*.
* In a very few cases, an accessory supplied called manual "help" may be of use in simplifying de-
mounting where excessive lubricant has been applied or for tyres coupled to special rims.
- A pedal-controlled pneumatically operated wheel lift (optional) which loads and unloads the wheel
to and from the working position
- A traditional bead breaker (supplied on demand) with double acting cylinder, conceived to work
mainly on wheels with steel rims: max diameter 17" – max width 320 mm.
Thanks to this machine, the following goals are also achieved:
- Minimized physical effort on the part of the operator;
- No risk of damage to rim and tyre.
Each machine carries a plate with its identification and some technical data.
As well as the manufacturer's details, it indicates:
mod. - Machine model;
V - power supply voltage in Volts;
A - Input voltage in Amperes;
kW - Absorbed power in kW;
Hz - Frequency in Hz;
Ph - Number of phases;
bar - Operating pressure in bar;
Serial No. - Machine serial number;
EC - EC marking.
WARNING
It is forbidden to modify or remove the data in the plate.
User Manual TECO 100 Variant
35