Safety Standards - ELSEA TITANUS BL375T Manuel D'instructions

SAFETY STANDARDS

ATTENTION!
1. All current-carrying parts must be protected against the water jet;
2. protect the fan from the rain;
3. use the device uniquely in work situations for which it was designed and built.
4. make sure that the electrical system to which it is connected to the aspirator is suitable and
efficient;
5. ensure that the voltage and power frequency coincide with those reported on the vacuum
cleaner technical data;
6. do not start the machine in case of suspected failure;
7. check the control panel of conservation status;
8. do not pull the power cord;
9. this device is not designed to pick up hazardous dust, it is prohibited from using this machine
in ATEX zones;
10. never leave the appliance unattended during working phases. Do not leave the appliance
unattended and poised or stairs, or in places where the balance is poor;
11. the appliance must be disconnected from its power source during cleaning or maintenance and
when replacing spare parts.
4 U S E
The industrial cleaner range TITANUS BL375T -monophase motor is suitable for continuous use.
The machine is mounted on sturdy wheels.
It is designed for the extraction of dust and machining residues.
You can not use the machine eg in dust, or explosive gases.
Any other use is considered improper and therefore a source of danger, as they can cause serious
damage to property and people as well as the machine itself.
Any transaction which is not linked to the normal operating cycle of the machine is to be considered
improper, so any maintenance, repair, change brushes, etc., Should be undertaken with the machine
switched off and de-energized.
The next section describes the main operations to be performed on TITANUS BL375T:
TITANUS BL375T
Instruction Manual
Non-permitted uses can lead to electrical shock,
explosion or death
18
en
REV 00