Introduction; Unpacking; Positioning; Connection - Dali SUB K-14 F Manuel

Les langues disponibles

1.0 INtrODUctION

Congratulations on your new DALI SUB K-14 F subwoofer. Please read this manual thoroughly

before unpacking and installing the subwoofer in order to get the most from your purchase.

You can find more information on our website: www.dali-speakers.com or by contacting your

authorised DALI dealer.

Remember to sign up for the DALI newsletter at www.dali-speakers.com.

Enjoy!

Be careful not to damage the contents when unpacking the parts. Check that all parts are

included in the cardboard box (see Table 1). Keep the packaging materials in case your speaker

needs to be relocated or serviced.

Both the amount and quality of the deep bass depend on the size and shape of the room, the

position of the subwoofer(s) and the main speakers. If positioned near a side or back wall, the

bass will be accentuated. A corner position will accentuate it even more, and we recommend

this position, as it increases the maximum bass output while simultaneously reducing the risk

of overloading your subwoofer.

DALI SUB K-14 F features a front-firing woofer, a down-firing bass port and, at the rear side of

the subwoofer, an amplifier metal plate which can become hot when the subwoofer is powered.

Make sure that the woofer and the bass port are not blocked or covered. Ensure that there is a

minimum distance of 5 cm / 2" between the metal plate and the nearest object in the room to

secure a free airflow.

DALI SUB K-14 F can be used with spikes or rubber bumpers under the speakers, see Figure

1. Be careful not to over tighten the locking nuts. Spikes or rubber bumpers can improve the

sound quality. You can try both to hear what gives the best sound quality in your setup. Please

be aware, that spikes may damage the floor.

DALI SUB K-14 F has a built-in power amplifier with an active crossover. The inputs of the

subwoofer amplifier should be connected to your stereo or surround sound (pre-) amplifier/

receiver using a RCA cable (sold separately).

note: When changing connections, always disconnect the mains voltage from the subwoofer

to prevent damage.

Table des Matières