Amplifier Back Plate; Technical Specifications - Dali SUB K-14 F Manuel

10.0 AMPLIFIEr BAcK PLAtE (SEE FIGUrE 3)
A) VOLUME control: Turn the control towards "Max" to increase the sound level. To reduce the
sound level, turn the control towards "Min".
B) CROSSOVER control: Adjustment of the crossover frequency from 40 Hz to 120 Hz.
C) PHASE switch: Toggle the phase of the subwoofer to either 0° or 180°.
D) LINE input: Connect the "L" input connector (white) to the LEFT RCA line output connector
of your stereo/surround sound (pre-) amplifier. Connect the "R" input connector (red) to the
RIGHT RCA line output connector of your stereo/surround sound (pre-) amplifier.
E) LFE input: Connect the "LFE" input connector (black) to the LFE RCA line output of your
surround sound amplifier.
F) POWER switch: Set the switch to 'ON' to power up the subwoofer. Set the switch to 'OFF' to
power off the subwoofer.
G) FuSE compartment: If the subwoofer fails to power up when connected to the mains and
the POWER switch is set to ON, the fuse may have blown or be faulty. Replace the fuse with
the same type as originally supplied – see fuse type on the amplifier back plate. If the fuse
blows repeatedly, have the subwoofer checked at an authorised service centre – contact
your authorised dealer.
H) MAINS connector: Connect the supplied power cord to the MAINS connector and your
mains outlet.
I) POWER MODE switch:
• 'ON': The power to the subwoofer will be controlled by the POWER switch.
• 'AUTO': When the main power switch is on, the subwoofer amplifier will turn on when an
input signal is detected on one of the inputs. When a signal is not detected for approximately
20 minutes, the subwoofer amplifier will go into standby-mode.
• 'OFF': The subwoofer will immediately go into standby mode.
J) MAINS voltages switch: If you are going to use the DALI SUB K-14 F in a county that uses
120V you MUST move this switch from 220-240V to 100-120V.
• WarnInG: maKe Sure tHat correct VoLtaGe IS SuppLIeD from your maInS
outLet Before connectIon.

11.0 tEcHNIcAL SPEcIFIcAtIONS

In Table 2 you will find the most common specifications for our subwoofers. Please have in mind
that there are countless methods for measuring subwoofers. However, none of them tell you
anything useful about how a subwoofer really sounds. Only your ears can decide whether one
subwoofer sounds better than another. Like all our speakers, DALI SUB K-14 F is designed to
reproduce music as honestly as possible.
Enjoy your new DALI SUB K-14 F!
16