Installation Instructions And Door Reversibility - VESTEL VEKF2016 Guide D'utilisation

Installation instructions and door reversibility

Installation
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
1. See fig.A for the necessary attachment components.
2. Insert trim flap
1
3. Pass the power cord through ventilation shaft and position it so that the appliance could
be easily plugged in once it has been installed. (fig.B - fig.C)
4. Take out the trim gasket
reverse side of the door hinges of the appliance. (fig.D - fig.E)
5. Raise the appliance and slide into the kitchen unit.
6. Push the appliance to the reverse side of the door hinges providing that the trim gasket
covers the space between the appliance and the kitchen unit.
7. Align the front feet with front surface of the kitchen unit. (fig.F)
8. Screw the front feet by using screws
9. Screw trim flap
10. Screw guides
3
11. Lean appliance door to unit door as it is opened at right angle.
12. Slide rails into guides
4
13. Screw the rails
14. Set 1~2 mm gap on handle side between unit itself and unit door by adjusting guides
That is vital for appliance performance. (fig.H)
into slot and screw by screws
located on the side panel of the appliance and stick it on
4
to kitchen unit using screws
1
to appliance door with screws
aligning the groove. (fig.H)
3
to the unit door with screws
4
. (fig.D)
6
. (fig.F)
5
. (fig.G)
5
. (fig.H)
6
. (fig.H)
5
EN -39-
2
.
3