Dreve Labormat SD Mode D'emploi page 26

Labormat SD
7.3 Changing the water
In order to obtain consistently good
results when cleaning and boiling out
models, the wax dissolved in water
should be removed regularly (once a
week, more often if used more fre-
quently). Do this by setting the temper-
ature controller (24) to 0 °C or switching
off the device and allowing it to cool
(ideally overnight).
The wax dissolved in the water auto-
matically collects as a layer on the sur-
face. After removing the flask baskets
and support plates (55), this layer can
be scooped out along with any other
impurities floating on the surface.
When giving the device an overall and
thorough cleaning (min. once a week,
more frequently if used more often),
the device can be switched back on
again after scooping out the wax layer
and preheated to 65 °C.
The water inside the device can be
pumped off using the discharge hose
supplied. Do this by removing a spray
tube (47) (see next section) and estab-
lishing the tube/Labormat SD con-
nection with the aid of the bayonet
coupling attached to the tube. Place
the other end of the tube in a drain
(e. g. sink).
50
Activate the pump with the aid of the
timer (18) or hold button (15). The
water is automatically pumped off until
3–4 cm sediment remains on the base.
The heavily-soiled residual water is not
pumped off but rather discharged via
a drainage valve (42) located on the
base of the water tank. Fully open the
lower front cover (5) (magnetic catch)
and drainage valve (42) using the red
shut-off valve. The residual water flows
off and is collected in the collection
basin (54) underneath. Remove rough
deposits and deposits adhering to the
inside of the water tank and rinse the
device with a little water. Close the
drainage valve (42). Detach the col-
lection basin (54) from the device and
dispose of the waste water. Fill with
fresh water as far as the maximum
mark outlined in the section on „Fill-
ing with water".
Important: Only dissolve Unisol W
in cold water; high water tempera-
tures cause foaming.
7.4 Cleaning the spray tubes
Pump mode can also enable rough by releasing the dummy plug (48) at
impurities to penetrate the spray the end of the tube, inserting the brush
tubes (47) along with the water. This into the spray tube (47) and use rotary
can impair the function of the spray and thrusting movements to release
nozzles and should be checked at reg- and remove rough dirt and calcium
ular intervals, cleaning if necessary. deposits. The tube should then be
This necessitates removal of the spray rinsed under running water.
tubes (47) which are connected to the The spray tubes are reassembled in the
water line in the device via bayonet reverse order to the process described
catches. Unlock the bayonet catch by above.
a half-turn to the right and gently pull
the entire spray tube (47) out at an Important: When inserting the
upward incline. A cleaning brush is spray tubes, ensure that the spray
supplied with each new device. Clean nozzles face downwards.
8. Labormat SD accessories
Waste water Fresh water
discharge hose supply hose
D51142KPL D1017E
Cleaning brush for
spray tubes
51074
51